TB 11-6625-2715-50
SECTION I
INTRODUCTION AND DESCRIPTION
b. Specifications.
1-1. Purpose and Scope. This bulletin provides
information for the periodic certification of Ammeter,
Ranges ..................................0 to 1.5 amperes
Simpson, model 2100. It is to be used by personnel
0 to 3 amperes
trained and qualified in the use of calibration equipment.
0 to 30 amperes
Since calibration personnel are trained and qualified in
Accuracy ................................2% of full scale value.
the usage of test and measuring equipment, detailed
instructions for operation and use of these equipments
are not contained in this bulletin.
c. Calibration.
1-2. Reporting of Technical Bulletin Improvements.
Interval ...................................In accordance with
The
reporting
of
errors,
omissions,
and
TB 43-180
recommendations for improving of this bulletin is
Time required .........................1 hour
authorized and encouraged. Submit reports on DA Form
Technique ..............................DC Low Frequency
2028 (Recommended Changes to Publications and
Blank Forms) directly to:
Commander, US Army
1-4. General Instructions. a. Calibration Reporting.
Electronics Command, ATTN:
AMSEL-MA-Q, Fort
During the performance of this procedure annotate DA
Monmouth, NJ 07703.
Form 2416 (Calibration Data Card) in accordance with
1-3. Descriptive Data. a. Identification.
TM 38-750.
Nomenclature.........................Ammeter (Multi range)
b. Test Instrument. Throughout this procedure the
Manufacturer ..........................Simpson Electric Co.
Test Instrument will be identified as TI (Test Instrument).
Model number ........................2100
Size .......................................5 in. x 5 in. x 6 in.
(approx.)
2