TB 9-5120-206-35
TEST INSTRUMENT
DRIVE BAR
SOCKET ADAPTER
TORQUE MOUNTING ASSEMBLY
FORCE/TORQUE INDICATOR
TORQUE CELL
e. Connect 500 ft-lb
TORQUE CELL to
FORCE/TORQUE INDICATOR,
using cable
supplied with FORCE/TORQUE INDICATOR.
f. Connect TORQUE CELL to FORCE/TORQUE INDICATOR using cable supplied
with FORCE/TORQUE INDICATOR.
Connect FORCE/TORQUE INDICATOR to
appropriate power source. Turn power switch to ON and allow the unit to warm up for
30 minutes. Select channel 3 using the CHANNEL + and keys.
NOTE
Whenever direction of torque is changed (cw or ccw),
FORCE/TORQUE INDICATOR setup must be changed and
TI must be exercised three times.
g. Press the F4 key on the FORCE/TORQUE INDICATOR until you see the
soft keys. Press the
soft keys as necessary to select the 500 ft-lb TORQUE
CELL and ccw direction. Insure the serial number matches the TORQUE CELL being
used.
h. Press the F4 key on the FORCE/TORQUE INDICATOR until you see the
UNIT soft key. Press the UNIT soft key as necessary to select ft-lb.
i. Press the SIGNAL pq? ? to select the GROSS mode of operation. Press
the F4 key on the TI indicator until you see the Acal soft key. Press the Acal soft key as
necessary to activate the Acal enunciator.
4