TB 9-5975-219-24
(e) Flow control: None.
(f) Click on the OK button.
e. Turn on Power switch on TI.
f. Connect ATE to 115 V ac power source and turn ATE POWER switch (rear panel) to on.
NOTE
It will take about 45 to 50 seconds for the unit to boot up. At
that time, the red LED on the side of the Ice box will stop
flashing, and shortly after that, a menu will appear in Hyper
Terminal on the laptop.
g. The Hyper Terminal will display the following depending on ATE being used:
NOTE
If using ATE PN# 13675099 and the hyper terminal display
boots up with a message that system is in Extended Mode,
follow instructions displayed to set the system to LEGACY
MODE.
(1) For ATE PN# 13625170:
A: Serial Ice Box
B: Wireless Ice Box
(2) For ATE PN# 13675099:
A: Serial Ice Box
B: WDS-A
C: WTKDMM
i. The Menu will appear as follows:
Serial Ice Menu
X: Auto Alignment, Auto References
Y: Auto Alignment, Manual References
Snn: External Verify, continuous, pin-pair nn
Znn: Present Stem nn
H: Test Controller Card
I: Test I/O Card
J: Test Power Supply Card
N: NATO Power Test
L: J4AB Probe Test
U: Unit Verify
A: J7 & DCA Reverse Diode Test
E: NATO Reverse Diode Test
K: W1 (DCA)Cable Loopback Test
F: W4 (TK) Cable Loopback Test
O: ICE Serial Cable Test
R: Reset Power Supply Trip
6