TB 9-6625-2197-50
(1) Deenergize and disconnect all equipment.
(2) Remove battery stick from TI.
(3) Disconnect cable (20) (fig. 4) from attenuator.
(4) Disconnect cable (10) (fig. 4) from connector J12 (11) (fig. 4A).
(5) Disconnect power supply extender cable from cable (8) (fig. 4) and connector
(6) Disconnect SMA connectors from card cage chassis, SUM and DIFF outputs.
(7) Place upper housing beside card cage chassis and reconnect cables (2) and
(8) Install upper housing into card cage chassis while sliding cables (2) and (3) (fig.
4) through seals to take up
slack.
(9) Install eight screws and washers (21) and (22) (fig. 4) located on lip of card
cage chassis.
(10) Place lower housing near card cage chassis and connect cable (20) (fig. 4)
to attenuator.
29