TB 9-6625-2326-24
WARNING
HIGH VOLTAGE is used or exposed during the performance of
this calibration.
DEATH ON CONTACT may result if
personnel fail to observe safety precautions.
REDUCE
OUTPUT(S) to minimum after each step within the
performance check where applicable.
NOTE
Ensure that there are no other PC cards installed in PCMCIA slots.
a. Insert TI into AN/PSM-95 or AN/PSM-95A PCMCIA slot. Do not connect test lead
connector at this time.
b. Power up AN/PSM-95 or AN/PSM-95A.
c. Once system has completed the boot process, insert "SPORT/MSD DMM
Maintenance Disk" into CD drive.
d. Software should auto-start and present a menu. If this does not occur, explore the
CD and run SPORT_MSD_CAL.exe.
e. At first menu screen, click on SPORT or MSD, depending on the default selection
that is presented.
f. If you are utilizing AN/PSM-95 (SPORT) to run this procedure, proceed to step g. If
utilizing AN/PSM-95A (MSD), proceed to step i.
g. On the proceeding menu screens, select Continue, then select ISAS DM224, then
select Setup & Calibration.
h. Proceed to step j.
i. On next menu screen, select ISAS - DM224.
j.
At this time you will be executing the software from the CD drive.
NOTE
A menu with the buttons "Install DM224 Driver" and "Run
DM224 Calibration Software" will be presented. If "Install
DM224 Driver" is inactive, the drivers have been previously
Software" and proceed. If the "Install DM224 Driver"
button is active, you must select it to install the drivers. You
will then need to remove the CD and reboot the SPORT or
MSD (if CD is not removed, computer will attempt to boot from
same CD). Once this is done, reinsert the SPORT/MSD DMM
Maintenance Disk. Once inserted, you should then proceed to
and
select
"Run
Software".
DM224
Calibration