TB 9-6625-2340-35
Paragraph
Page
Bandwidth switching ...........................................
Log scale switching
IF gain uncertainty...............................................
Scale fidelity .........................................................
Frequency response ..............................................
Sweep time accuracy ...........................................
Line related sidebands ........................................
Average noise level ...............................................
Residual response .................................................
Harmonic distortion..............................................
Out of band response ............................................
Gain compression..................................................
First LO output amplitude accuracy ...................
Sweep + tune out accuracy...................................
Fast sweep time accuracy.....................................
Low voltage power supplies .................................
90
Final procedure .....................................................
93
IDENTIFICATION AND DESCRIPTION
1. Test Instrument Identification.
This bulletin provides instructions for the
calibration of Spectrum Analyzer, Hewlett-Packard, Model 8566B. The manufacturer's
manual was used as the prime data source in compiling these instructions. The equipment
being calibrated will be referred to as the TI (test instrument) throughout this bulletin.
a. Model Variations. None that affect calibration.
b. Time and Technique. The time required for this calibration is approximately 16
hours, using the dc and low frequency and microwave technique.
2. Forms,
Records, and
Reports
a. Forms, records, and
reports required for calibration personnel at all
levels are
prescribed by TB 750-25.
b. Adjustments to be reported are designated (R) at the end of the sentence in which
they appear. When adjustments are in tables, the (R) follows the designated adjustment.
Report only those adjustments made and designated with (R)
3. Calibration
Description. TI
parameters and
performance specifications which
pertain to this calibration are listed in table 1.