*TB 9-6670-251-35
DEPARTMENT OF THE ARMY TECHNICAL BULLETIN
CALIBRATION PROCEDURE FOR
RESILIENCY TESTERS (GENERAL)
Headquarters, Department of the Army, Washington, DC
14 February 1984
♦REPORTING OF ERRORS♦
You can help improve this publication by calling attention to errors and by
recommending
improvements
and
stating
your
reasons
for
the
recommendations. Your letter or DA Form 2028, Recommended Changes to
Publications, should be mailed directly to Commander, U.S. Army Aviation and
Missile Command, ATTN: AMSAM-TMD-EP, Redstone Arsenal, AL 35898-5000.
FAX to DSN 788-2313 (Commercial: 256-842-2313) A reply will be furnished
directly to you.
Paragraph
Page
SECTION
IDENTIFICATION AND DESCRIPTION
Test instrument identification............................
Calibration description .......................................
EQUIPMENT REQUIREMENTS
Equipment required ...........................................
Accessories required ...........................................
CALIBRATION PROCESS
Preliminary instructions ....................................
Equipment setup ................................................
Push-pull type resiliency testers .......................
Suspended type resiliency testers .....................
Final procedure ..................................................
__________
*This bulletin supersedes TB 9-6670-251-50, 29 July 1977.
1