SUPERSEDED COPY DATED 1 JULY 1973
DEPARTMENT OF THE ARMY TECHNICAL BULLETIN
CALIBRATION PROCEDURE FOR
(GENERAL)
Headquarters, Department of the Army, Washington, DC
27 June l988
Approved for public release; distribution is unlimited
REPORTING OF ERRORS
You can help improve this publication by calling attention to errors and by
recommending
improvements
and
stating
your
reasons
for
the
recommendations. Your letter or DA Form 2028, Recommended Changes to
Publications, should be mailed directly to Commander, U.S. Army Aviation and
Missile Command, ATTN: AMSAM-TMD-EP, Redstone Arsenal, AL 35898-5400.
FAX to DSN 788-2313 (commercial 256-842-2313). A reply will be furnished
directly to you.
Paragraph
Page
IDENTIFICATION AND DESCRIPTION
Test instrument identification ...........................
Forms, records, and reports ..............................
Calibration description ......................................
EQUIPMENT REQUIREMENTS
Equipment required ..........................................
Accessories required ..........................................
HYDRAULIC GAGES
Preliminary instructions ...................................
Equipment Setup ...............................................
0 to 10,000 psi hydraulic gages
(0 to 20 percent accuracy) ..............................
0 to 5000 psi panel mounted hydraulic gages
(1.0 to 20 percent accuracy) ...........................
0 to 10,000 psi panel mounted hydraulic
gages
(0.1 to 1.0 percent accuracy) ..........................
Final procedure...................................................
__________
* This bulletin supersedes TB 9-6685-319-50, 1 July 1973, including all changes.