TM9-4935-294-15/2
(4)Select equipment required for signal source leveling
from appropriate section of table listing equipment
3-13.
Operational Check and Troubleshooting of
selection for signal source leveling in chapter 2, section
II, of TM 9-4931-294-15/1.
a. Preliminary Procedure.
(5)Connect equipment as shown in the
(1)Set signal source controls as indicated below:
appropriate section of the figure illustrating the setups for
(a)
HI VOLT switch to OFF.
signal source leveling in chapter 2,section II of TM 9-
(b)
AC POWER switch to OFF.
4931-294-15/1 in accordance with the frequency of
(c)
SQUARE WAVE SELECTOR switch to
operation.
OFF.
(d)
MODE selector switch to CW.
NOTE
(e)
RF LEVEL SELECTOR switch to XTAL.
Do not connect thermistor mount to PHASE
(f)
RF LEVEL-LEVEL ADJ fully ccW.
LOCK connector.
(2)Select rf head which is appropriate for
b. Operational Check Chart of Signal Source. After
frequency band of interest and plug head into signal
performing the preliminary procedures described in a
source.
(3)Interconnect rf head and tunable synchronizer
complete operational procedures refer to paragraph on
in accordance with appropriate figure illustrating signal
signal source operating procedure in chapter 2, section
source interconnections in chapter 2, section II, of TM
II, of TM 9-4931-294-15/1.
9-4931-294-15/1.
3-27