TB 9-6625-2197-50
NOTE
Card cage chassis connector (2) (fig. 4) will be referred to as
DIFF and (3) (fig. 4) will be referred to as SUM through the
rest of this procedure.
l.
Install SMA to BNC female connections on SUM and DIFF outputs.
m. Place lower housing beside card cage chassis.
n. Connect one end of power supply extender cable (part of transponder test set kit) to
lower housing P1 cable (8) (fig. 4) (this cable was disconnected in g (4) above) and the other
end of power supply extender cable to connector (11) (fig. 4).
o. Arrange lower housing for best connection of P1
cable (10) (fig. 4) to
connector J12
(15) (fig. 4, inset A) and reconnect cable (20) (fig. 4) to attenuator on lower housing.
p. Install fully charged battery stick into TI.
q. Place lower housing on handles beside TI for easy access of test pushbuttons.
r. Arrange card cage chassis for a convenient view of display and easy access to SUM
and DIFF connections.
s. Connect equipment as
shown in
figure 5, CONNECTION A, and
allow sufficient
time for equipment warm-up.
10