TM 11-6625-3008-24P
SECTION I
INTRODUCTION
1.
Scope
NOTE
This manual lists spares and repair parts; special tools;
Cannibalization or salvage may be used
special test, measurement, and diagnostic equipment
as a source of supply for any items
(TMDE), and other special support equipment required
source coded above except those coded
for performance of organizational, direct support, and
XA and aircraft support items as
general support maintenance of the 0-1804/USM-410(V).
restricted by AR 750-1.
It authorizes the requisitioning and issue of spares and
(2) Maintenance code. Maintenance codes
repair parts as indicated by the source and maintenance
are assigned to indicate the levels of maintenance
codes
authorized to USE and REPAIR support items.
The
2.
General
maintenance codes are entered in the third and fourth
This Repair Parts and Special Tools List is divided into
positions of the Uniform SMR code as follows.
the following sections:
(a) The maintenance code entered in the
third position will indicate the lowest maintenance level
spares and repair parts authorized for use in the
authorized to remove, replace, and use the support item.
performance of maintenance. The list also includes
The maintenance code entered in the third position will
parts which must be removed for replacement of the
indicate one of the following levels of maintenance.
authorized parts. Parts lists are composed of functional
Code
Application/Explanation
groups numeric sequence, with the parts in each group
O
Support item is removed, replaced, used at the
listed in figure and item number sequence.
Bulk
organizational level.
materials are listed in NSN sequence.
H
Support item is removed, replaced, used at the
b. Section III.
Special Tools List.
Not
general support level.
applicable.
(b) The maintenance code entered in the
fourth position indicates whether the item is to be repaired
Pan Number Index. A list, in National item identification
and identifies the lowest maintenance level with the
number (NIIN) sequence, of all National stock numbers
capability to perform complete repair (i e., all authorized
(NSN) appearing m the listings, followed by a list, in
maintenance functions). This position will contain one of the
alphanumeric sequence, of all part numbers appearing in
following maintenance codes:
the listings. National stock numbers and part numbers
Code
Application/Explanation
are cross-referenced to each illustration figure and item
H
The lowest maintenance level capable of
number appearance.
complete repair of the support item is the general
3.
Explanation of Columns
support level.
a. Illustration.
This column is divided as
Z
Nonreparable. No repair is authorized.
follows.
(3) Recoverability code. Recoverability codes
(1) Figure number. Indicates the figure
are assigned to support items to indicate the disposition
number of the illustration on which the item is shown.
action on unserviceable items. The recoverability code is
(2) Item number. The number used to
entered in the fifth position of the Uniform SMR Code format
identify item called out in the illustration.
as follows :
b. Source, Maintenance, and Recoverability
Recoverability
(SMR) Codes.
Code
Definition
(1) Source code. Source codes indicate
Z
Nonreparable item.
When unserviceable,
the manner of acquiring support items for maintenance,
condemn and dispose at the level indicated min
repair, or overhaul of end items. Source codes are
position 3.
entered in the first and second positions of the Uniform
H
Reparable item When uneconomically reparable,
SMR Code format as follows.
condemn and dispose at the general support
Code
Definition
level.
PA Item procured and stocked for anticipated or
c. National Stock Number. Indicates the National
known usage
stock number assigned to the item and will be used for
XA Item is not procured or stocked because the
requisitioning purposes.
requirements for the item will result in the
replacement of the next higher assembly.
XB Item is not procured or stocked.
If not
available through salvage, requisition.
1