TM 9-4935-294-15/2
c. Reinstallation of Digital Multimeter. To reinstall
then lift slide locking latches and remove unit from
combination case.
the digital multimeter, refer to figure 4-7 and reverse the
order of removal.
(3) Disconnect power supply line cord from
d. Reinstallation of Digital Counter. To reinstall the
combination case receptacle.
digital counter, refer to figure 4-7 and reverse the order
b. Reinstallation. To reinstall the microwave receiver,
of
removal.
refer to figure 4--5 and reverse the order of removal.
b. Removal of Digital Multimeter. To remove the
4--12. Removal and Reinstallation of Rf Head
digital multimeter, refer to figure 4--7 and proceed as
Assemblies in Combination Case
follows:
No. 4.
a. Removal. To remove the six rf heads from
(1) Slide digital multimeter (5) forward until the
combination case no. 4, refer to figure 4--6 and proceed
slide lock in full forward position, then lift slide locking
as follows:
latches and remove multimeter (5) from combination
case (1).
(1) Rotate the right-- and left--hand pawl fasteners
to release position.
(2) Disconnect power supply line cord from
(2) In sequence, slide each rf head (2 through 7)
combination case receptacle.
forward and remove.
Note. Each rf head can be removed independently, if
4-14. Removal and Reinstallation of Modu-
required.
lator in Combination Case No. 10.
b. Reinstallation. To reinstall the rf heads in the
a. Removal.
To remove the modulator from
combination case, refer to figure 4-6 and reverse the
combination case no. 10, refer to figure 4--8 and
order of removal.
proceed as follows:
4-13. Removal and Reinstallation of Digital
(1) Remove four retaining screws (3) and
Counter and Digital Multimeter In
washers (4) securing modulator (2) to combination case
Combination Case No, 5.
(1).
a. Removal of Digital Counter. To remove the digital
counter in combination case no. 5, refer to figure 4--7
(2) Slide modulator (2) forward until the elides
and proceed as follows:
lock in full forward position, then lift slide locking latches
and remove modulator (2) from combination case (1).
(1) Remove eight retaining screws (3) and washers
(4) securing digital counter (2) to combination case (1).
(3) Disconnect power supply line cord from
combination case receptacle.
(2) Slide digital counter (2) forward until the slides
lock in full forward position, then lift slide locking latches
b.Reinstallation. To reinstall the modulator refer to
and remove digital counter (2) from combination case
(1).
4-15. Deleted
(3) Disconnect power supply line cord from
combination case receptacle.
Change 1 4-10
