TB 9-6625-2309-35
NOTE
When software level 1.08a is used to change distance
parameters (ZERO-KM SETTING) of an optical module for a
given wavelength, that particular optical module must remain
CAUTION
Never connect/disconnect keyboard or external disk drive to TI
with power on or damage may occur to TI.
a. Perform setup steps (1) through (4) below:
(1) Place TI ON/OFF switch to OFF.
(2) Connect keyboard cable to KEY BD connector located on rear of TI.
(3) Connect external disk drive cable to EXT.DSK connector located on rear of TI.
(4) Place TI ON/OFF switch to ON.
b. To install software level 1.08a, perform steps (1) through (22) below:
(1) Place 720K 3.5 inch floppy disk containing files in external disk drive.
NOTE
TI external drive has 720K format and can only read or write to
a 3.5 inch 720K floppy disk.
(2) At TI display crt screen Press Any Main Panel Key To Begin, press any main
panel key.
(3) Press HELP pushbutton.
(4) Press MORE softkey.
(5) Press STORAGE MAINT. softkey.
(6) Press CHANGE DRIVE softkey.
(7) Press DEFAULT Drive A softkey.
(8) Press MORE softkey.
(9) Press STORAGE MAINT. softkey.
(10) Press COPY FILES softkey.
33