TB 11-6625 -3263-25
b. Each TEMOD item listed in chapter 4, section I (Equipment Description) includes the
following information: Nomenclature, Line Item Number (LIN), Nat ional Stock Number (NSN),
Manufacturer, Model Number, Commercial and Government Entity (CAGE), BOIP, and
specifications.
c. The replacement list for each TEMOD item is divided in two separate sections: Items
Replaced and Removed from Field and Items Potentially Replaceable. The "Items Replaced and
Removed from Field" section contains items of TMDE that will be unconditionally replaced and
removed from the Army unit. The section of "Items Potentially Replaceable" lists TMDE items that
can be replaced by the TEMOD item; however, certain conditions exist that may prevent the item
from being replaced in all applications. These conditions are identified by condition codes in the
right hand column of the list. A description of the applicable condition codes follows the list.
d. The TEMOD replacement lists show the calibratable component for the end item.
Calibratable components are shown as "CC:" and listed under the item. For example:
AN/GRM -50
CC: SG-479/U
The above entry shows the SG -479/U is the calibratable component of the AN/GRM-50
and it is replaceable by the same TEMOD item replacing the AN/GRM -50.
e. The following steps are required to identify a replacement item. They describe the
replacement process from the on-hand or authorized TMDE item to the TEMOD replacement.
(1)
Identify the on-hand or authorized item.
(2)
Check chapter 4, section II, to determine the TEMOD replacement.
(3)
Check chapter 4, section I, to determine status, and applicable condition codes. If
the item is listed under the "Items Replaced and Removed from Field," it will be replaced and no
further action is required. For an item listed under the "Items Potentially Replaceable" do (4)
through (7) below.
(4)
Compare the on-hand/authorized item description to the TEMOD item description.
Pay special attention to the conditions described in the applicable condition codes.
(5)
Compare the TEMOD item technical characteristics against your requirements.
(6)
Decide whether to replace or not.
(7)
Initiate changes based on replacement decisions.
(8)
If additional information is required, contact TEMOD at:
Assistant Product Manager
Test, Measurement and Diagnostic Equipment
ATTN: SFAE-CSS-CS-T-TEMOD
Redstone Arsenal, AL 35898-5000
3-2