DEPARTMENT OF THE ARMY TECHNICAL BULLETIN
CALIBRATION PROCEDURE FOR
SIMPLIFIED TEST EQUIPMENT FOR
(STE/ICE-R)
Headquarters, Department of the Army, Washington, D. C.
29 March 2005
Distribution Statement A: Approved for public release; distribution is unlimited.
REPORTING OF ERRORS AND RECOMMENDING IMPROVEMENTS
You can improve this manual. If you find any mistakes or if you know of a way to improve
these procedures, please let us know. Mail your letter, DA Form 2028 (Recommended Changes
to Publications and Blank Forms), or DA Form 2028-2 directly to: Commander, U.S. Army
Aviation and Missile Command, ATTN: AMSAM-MMC-MA-NP, Redstone Arsenal, AL 35898-
5000. A reply will be furnished to you. You may also provide DA Form 2028 information to
AMCOM via e-mail, fax, or the World Wide Web. Our fax number is DSN 788-6546 or
Commercial 256-842-6546. Our e-mail address is: 2028@redstone.army.mil. Instructions for
sending an electronic 2028 may be found at the back of this manual. For the World Wide Web,
use https://amcom2028.redstone.army.mil.
Paragraph
Page
IDENTIFICATION AND DESCRIPTION
Test instrument identification ................................
Forms, records, and reports.....................................
Calibration description ............................................
EQUIPMENT REQUIREMENTS
Equipment required .................................................
Accessories required.................................................
CALIBRATION PROCESSFOR VEHICLETEST METER(VTM)
Preliminary instructions..........................................
Equipment setup ......................................................
Dc voltage .................................................................
Resistance .................................................................
Dc current .................................................................
Frequency .................................................................
RPM ..........................................................................
Pressure ....................................................................
Vacuum .....................................................................
Final procedure ........................................................
_____________
*This technical bulletin supersedes TB 9-4910-555-35, dated 24 July 2003, including all changes.
