SECTION I IDENTIFICATION AND DESCRIPTION

TB 9-4920-459-24

SECTION I

IDENTIFICATION AND DESCRIPTION

1. Test Instrument Identification.

This bulletin provides instructions for the

calibration of Pitot and Static Systems Tester, Druck, Model TS-4463( )/P.

The

manufacturer's manual was used as the prime data source in compiling these instructions.

The equipment being calibrated will be referred to as the TI (test instrument) throughout

this bulletin.

a. Model Variations. None.

b. Time and Technique. The time required for this calibration is approximately 3

hours, using the physical techniques.

2. Forms, Records, and Reports

a. Forms, records, and reports required for calibration personnel at all levels are

prescribed by TB 750-25.

b. Adjustments to be reported are designated (R) at the end of the sentence in which

they appear. When adjustments are in tables the (R) follows the designated adjustment.

Report only those adjustments made and designated with (R).

3. Calibration Description. TI parameters and performance specifications which

pertain to this calibration are listed in table 1.

Table 1. Calibration Description

Test instrument parameters

Performance specifications

Range: -1,500 to 50,000 ft

Altitude

Resolution: 1 ft

Accuracy: 10 feet or 0.1% of command

Airspeed

Range: 20 to 400 knots

Resolution: 0.1 knots

Accuracy: 1.5 knots from 20 to 60 knots 1.0 knots

above 60 knots

EQUIPMENT REQUIREMENTS

4. Equipment Required. Table 2 identifies the specific equipment to be used in this

calibration procedure. This equipment is issued with Secondary Transfer Calibration

Standards Set AN/GSM-287, AN/GSM-705, and Secondary Reference Calibration

Standards Set NSN 4931-00-621-7878. Alternate items may be used by the calibrating

activity. The items selected must be verified to perform satisfactorily prior to use and must

bear evidence of current calibration. The equipment must meet or exceed the minimum use

specifications listed in table 2. The accuracies listed in table 2 provide a four-to-one ratio

between the standard and TI. Where the four-to-one ratio cannot be met, the actual

accuracy of the equipment selected is shown in parenthesis.