TB 9-4933-220-50
Section III. PRELIMINARY OPERATIONS
6. Preliminary Instructions
NOTE
a. The instructions outlined in this section are
Unless otherwise specified, verify the
preparatory to the calibration process. Personnel should
results of each test and take
become familiar with all sections before beginning the
corrective action whenever the test
calibration.
requirement is not met before
continuing with the calibration.
b. Items of equipment used in this procedure are
referenced within the text by common name and item
7. Equipment Setup
identification of equipment referenced by item numbers
a. Remove TI from carrying case.
b. Position TI on a nonconductive surface. Make it
WARNING
accessible from front and back.
HIGH VOLTAGE is used during the
c. If TI meter does not indicate zero, adjust to zero
performance of this calibration.
using adjustment screw located below meter face.
DEATH ON CONTACT may result if
personnel fail to observe safety
precautions.
5
