TB 9-6625-003-35
(2) Adjust test oscillator frequency for 1000 Hz and output for an on-scale
indication.
(3) Adjust test oscillator frequency for peak indication on TI meter, reducing
amplitude as required.
(4) Adjust test oscillator amplitude for a 0-dB indication on TI meter 0 to 10 dB
scale. Test oscillator output meter will indicate 0.3 V or less.
(5) Vary output of autotransformer (A3) from 105 to 125 V while maintaining 0 dB
indication on TI meter. Test oscillator output meter will indicate 0.3 V or less.
(6) Adjust autotransformer for a 115-V ac output.
(7) Adjust test oscillator amplitude for 0.04 V and record TI meter indication.
(8) Remove equipment-setup and connect termination (B7) to TI INPUT.
(9) Set SWR-DB switch to 60. If TI meter does not indicate less than (down-scale)
indication recorded in (7) above, perform b below.
Figure 1. Model-adjustment-top view.
7
