TB 9-6625-2250-35
(16) TI MKR indication will be within 6.1 dB of indication recorded in (6) above.
Record TI MKR indication.
(17) Disconnect signal generator from TI.
(18) Connect TI 10 MHz REF IN/OUT to synthesizer/level generator 40/N MHz
REF INPUT.
(19) Connect synthesizer/level generator OUTPUT 50Ω to TI INPUT 50Ω.
(20) Press synthesizer/level generator keys to values as listed in (a) through (c)
below:
(a) FREQUENCY to 10 MHz.
(b) AMPLITUDE to -4 dBm.
(c) AMPTD INCR to 0.1 dB.
(21) Press TI MARKER PEAK SEARCH key.
(22) Slowly adjust synthesizer/level generator amplitude until TI MKR indication is
as close as possible to the indication recorded in (16) above.
(24) Press FREQUENCY key then [CENTER FREQ] to 1 MHz.
(25) Press MARKER PEAK SEARCH key.
(26) TI MKR indication will be within 6.1 dB of indication recorded in (6) above.
[CENTER FREQ] 100 kHz and 10 kHz settings.
NOTE
Do not perform if indications in paragraph 17 are within
tolerance.
a. Performance Check
NOTE
Perform measuring receiver and sensor module (11792A) ZERO
and CALIBRATE.
(1) Connect equipment as shown in figure 5.
36 CHANGE 1
PIN: 069371-001
