TB 9-6650-233-35
IDENTIFICATION AND DESCRIPTION
the Optical Power Test Set TS-4358/G. Purchase Description/Specification TEMOD-91-01,
dated 12 November 91, TM 9-6650-906-12, and TM 9-6650-906-40 were used as the prime
data sources in compiling these instructions. The equipment being calibrated will be
referred to as the Optical Power Meter (OPM) or Stabilized Light Source (SLS) throughout
this bulletin.
a. Model Variations. None
b. Time and Technique. The time required for this calibration is approximately 1
hour, using the dc and low frequency technique.
prescribed by TB 750-25.
b. Out-of-tolerance conditions to be reported are designated (R) at the end of the
sentence in which they appear. When these conditions are in tables, the (R) follows the
designated adjustment. Report only those out-of-tolerance-conditions designated with (R).
which pertain to this calibration are listed in table 1.
Optical Power Meter (OPM)
Test instrument parameter1
Performance specifications
850 nm, 1310 nm, 1550 nm
Range
2,3: -50 to -6 dBm
Accuracy: -10 dBm:
0.35 dB
-50 to -6 dBm: 0.50 dB
Stabilized Light Source (SLS)
850 nm, 1300 nm (multimode)
Range: -20 dBm
Accuracy: 2.5 dB
1310 nm, 1550 nm (singlemode)
Range: -26 dBm
Accuracy: 2.5 dB
1
OPM not tested at 1300 nm
2Not
tested below -50 dBm and above -6 dBm
3Not tested above -10 dBm at 850 nm.
EQUIPMENT REQUIREMENTS
calibration procedure. This equipment is issued with Secondary Transfer Calibration
Standards Set AN/GSM-286. Alternate items may be used by the calibrating activity. The
items selected must be verified to perform satisfactorily prior to use and must bear
evidence of current calibration. The equipment must meet or exceed the minimum use
