(11) Remove RS-232 cable from main board.
(12) Assemble main board to keypad.
(13) Install six screws in main board and keypad.
(14) Assemble keypad and main board to back assembly.
(15) Place OPM face down and replace six screws (R).
a. Performance Check
(1) Remove SLS from rubberized case and record actual output wavelengths as
indicated by manufacturer label located on back of case.
(2) Connect SLS to LIGHTWAVE MULTIMETER as shown in figure 4,
CONNECTION A.
NOTE
Multimode optical fiber jumper cables are not provided with
FOCUS. Use multimode optical fiber jumper cable provided
with TS-4358/G, optical power test set.
OPTICAL INPUT
LIGHTWAVE
NOTE:
USE FC-FC MULTIMODE OPTICAL FIBER JUMPER
FC CONNECTOR
CABLE WITH CONNECTION A
ADAPTER
AND
USE FC-FC SINGLEMODE OPTICAL FIBER
JUMPER CABLE WITH CONNECTION B
CONNECTION A
CONNECTION B
SINGLEMODE PORT
MULTIMODE PORT
STABILIZED
LIGHT SOURCE
