TB 9-6695-299-50
APPENDIX B - Continued
SAMPLE CALIBRATION TEST REPORT - CONTINUED
SAMPLE CALIBRATION TEST REPORT - CONTINUED
(negative) POLARITY switch positions
Input voltage (VIN) =______________________________V
OUTPUT SIGNAL
Measured output (VOUT)
Calculated mV/V output1
dial positions
(in V)
100
-0.04500000
_________________________ mV/V
90
- __________________
_________________________ mV/V
80
- __________________
_________________________ mV/V
70
- __________________
_________________________ mV/V
60
- __________________
_________________________ mV/V
50
- __________________
_________________________ mV/V
40
- __________________
_________________________ mV/V
30
- __________________
_________________________ mV/V
20
- __________________
_________________________ mV/V
10
- __________________
_________________________ mV/V
0
-/+ ________________
_________________________ mV/V
1
mV/V output = (VOUT / VIN) x 1000. Where VOUT = measured output, VIN = input voltage, percent = OUTPUT SIGNAL
dial position (100 = 1.0, 90 = 0.9, etc.)
Under the conditions stated, the above measured and computed values are in error by no more than 25 ppm of full
scale (dial setting of 100).
This calibration is traceable to and compatible with NIST measurements.
Calibration Report No: ________________
________________________
Temperature:
_______________
Calibrating Technician
Relative Humidity:
________________
________________________
Date:
_________________
Facility Chief
Page 2 of 2
B-2
