TB 9-6515-200-35
Table 2. Minimum Specifications of Equipment Required -- Continued
Table 3. Accessories Required
SECTION III
PRELIMINARY OPERATIONS
6. Preliminary Instructions
NOTE
Unless otherwise specified, verify the result of each test
a. The instructions outlined in paragraphs 6 and 7 are
and, whenever the test requirement is not met, take
preparatory to the calibration process. Personnel should
corrective action before continuing with the calibration.
become familiar with the entire bulletin before beginning
Adjustments required to calibrate the TI are included in
the calibration.
this procedure. Additional maintenance information is
b. Items of equipment used in this procedure are
contained in the manufacturer's manual for this TI
referenced within the text by common name and item
NOTE
identification number as listed in tables 2 and 3. For the
When indications specified in paragraphs 8 through 10
are not within tolerance, perform the power supply check
identification of equipment referenced by item numbers
prior to making adjustments. After adjustments are
made, repeat paragraphs 8 through 10. Do not perform
WARNING
power supply check if all other parameters are within
HIGH VOLTAGE is used or exposed during the per-
tolerance.
formance of this calibration. DEATH ON CONTACT
NOTE
may result if personnel fail to observe safety precautions.
Unless otherwise specified, all controls and control set-
tings refer to the TI.
3