TB 9-6625-2317-50
(2) On AM/FM test source, set TEST MODE switch to FM.
(3) Set audio analyzer SOURCE LEVEL to 229 mV and LP FILTER to 80.
(4) On measuring receiver, press FREQ pushbutton.
(5) On AM/FM test source, adjust CARRIER FREQUENCY TUNE control for 100
MHz displayed indication on measuring receiver.
(6) On measuring receiver, press FM pushbutton and record frequency modulation
displayed indication.
NOTE
Add filters on measuring receiver as necessary to indicate a
stable reading.
(7) Connect equipment as shown in figure 6, CONNECTION B.
(8) Press TI pushbuttons (on) as indicated in (a) through (d) below:
(a)
CARR FREQ then 1, 0, 0, MHz.
(b)
LEVEL DISPLAY to FM.
(c)
LEVEL DETECTOR MODE to PK-PK/2.
(d)
LOW PASS FILTER to 300 kHz.
11