TB 9-6625-396-50
SECTION III
6. Preliminary Instructions
a. The
instructions outlined in
paragraphs 6 and
7 are preparatory to the
calibration
process. Personnel should become familiar with the entire procedure before beginning the
calibration.
b. Items of equipment used in this procedure are referenced within the text by common
name and item identification number as listed in tables 2 and 3. For the identification of
equipment referenced by item numbers prefixed with A, see table 2, and for prefix B, see
WARNING
High VOLTAGE is used during the performance of this
fail to observe safety precautions.
NOTE
Unless otherwise specified, all controls and control settings
refer to the TI.
7. Equipment Setup
b. MAXIMUM SENSITIVITY switch to LOW Z.
c. RANGE switch to e.
d. ALL G switches to zero positions.
SECTION IV
NOTE
Unless otherwise specified, verify the results of each test and,
whenever the test requirement is not met, take corrective
action before continuing with the calibration. Adjustments
required to calibrate the TI are included in this procedure.
Additional maintenance information is contained in the
manufacturer's manual.
4