Table 3 Accessories Required - Continued
Section III. CALIBRATION PROCESS
of each test and, whenever the test require-
outlined in paragraphs 6 and 7 are preparatory to the
ment is not met, take corrective action before
calibration process. Personnel should become familiar
continuing with the calibration. Additional
with the entire bulletin before beginning the calibra-
maintenance information is contained in the
tion.
manufacturer's manual for this TI.
b. Items of equipment used in this procedure are
NOTE
referenced within the text by common name and item
When indications specified in paragraphs 8
identification number as listed in tables 2 and 3. For
and 11 are not within tolerance, perform the
the identification of equipment referenced by item
power supply check prior to making adjust-
numbers prefixed with A, see table 2, and for prefix B,
ments. After adjustments are made, repeat
see table 3.
WARNING
supply check if all other parameters are with-
HIGH VOLTAGE is used during the perfor-
in tolerance.
NOTE
mance of this calibration. DEATH ON CON-
TACT may result if personnel to observe
Unless otherwise specified, all controls and
safety precautions.
control settings refer to the TI.
NOTE
Unless otherwise specified, verify the results
in figure 1.
