Page
Paragraph
Section
.
.........
........
......
Test instrument identification
................
..
......
Calibration data card, DA Form 2416
...
.
....
.
.
...
.
Calibration description . . . . . . .
..
..
.
.
Equipment required.
Accessories required
Preliminary instructions
. ...
Equipment setup
.
.
Back-to-back flatness check
.
. .... ...
....
.
...
BB output harmonics
...
.
.
Attenuator accuracy. . . .
. . . . . . . . . . . . . . . 11
.....
Calibrate frequency accuracy.
.
.......
..................
Power supply. . . . . . . . . . . . . . . . .
......
................
....
Find procedure . . . . . . .
provides instructions for the calibration of BB Sweeper
Forms, records, and reports required for calibration
personnel at all levels are prescribed by TM 38-750.
ccessory, Hewlett. Packard Model 3744A. The
DA Form 2416 must be annotated in accordance with
manufacturer's instruction manual was used as the
prime data source in compiling these instructions. The
TM 38-750 for each calibration performed.
equipment being calibrated will be referred to as the TI
b. Adjustments to be reported on DA Form 2416 are
designated (R) at the end of the sentence in which they
) throughout this bulletin.
appear. Report only those adjustments made and
iations None
designated with (R).
b. The and Technique. The time required for this
calibration is approximately 2 hours, using the dc
formance specifications which pertain to this calibra-
tion are listed in table 1.