TB 9-4931-540-24
(g) ENTRY REFERENCE LEVEL to -15 dBm.
(3) Set synthesizer/level generator as listed in (a) through (c) below:
(a) FREQUENCY to 13.31 MHz.
(b) AMPLITUDE to -15 dBm.
(c) AMPTD INCR to 0.1 dBm.
(4) Press keys or set controls to values as listed in (a) through (d) below:
SWEEP ENTRY MANUAL to 13.31 MHz.
(a)
ENTRY CF STEP SIZE to 13.31 MHz.
(b)
ENTRY blue shift and then ENTRY CAL ON and wait for TI to calibrate.
(c)
ENTRY blue shift and then ENTRY CAL OFF.
(d)
or
keys, until TI
(5) Adjust synthesizer/level generator amplitude, using INCR
marker amplitude indicates -15 dBm.
(6) Press MARKER/CONTINUOUS ENTRY OFFSET key to on and then press
MARKER/CONTINUOUS ENTRY ENTER OFFSET key.
key. TI
(7) Press SWEEP ENTRY MANUAL key and then ENTRY STEP
marker amplitude indication will be <-80 dBm.
key. TI marker amplitude indication will be <-80 dBm.
(8) Press ENTRY STEP
(9) Disconnect low pass filter No. 1 from TI and synthesizer/level generator.
(10) Connect synthesizer/level generator OUTPUT 50
to low pass filter No. 2 input
and connect low pass filter No. 2 output to TI 50-75 input.
(11) Set synthesizer/level generator as listed in (a) through (c) below:
(a) FREQUENCY to 20.01 MHz.
(b) AMPLITUDE to -15 dBm.
(c) AMPTD INCR to 0.1 dBm.
(12) Press keys or set controls to values as listed in (a) through (e) below:
MARKER/CONTINUOUS ENTRY OFFSET to off.
(a)
SWEEP ENTRY MANUAL to 20.01 MHz.
(b)
ENTRY CF STEP SIZE to 20.01 MHz.
(c)
ENTRY blue shift and then ENTRY CAL ON and wait for TI to calibrate.
(d)
ENTRY blue shift and then ENTRY CAL OFF.
(e)
or
keys, until TI
(13) Adjust synthesizer/level generator amplitude, using INCR
marker amplitude indicates -15 dBm.
(14) Press MARKER/CONTINUOUS ENTRY OFFSET key to on and then press
MARKER/CONTINUOUS ENTRY ENTER OFFSET key.
key.
(15) Press SWEEP ENTRY MANUAL key and then ENTRY STEP
TI
OFFSET amplitude indication will be <-80 dBm.
(16) Disconnect low pass filter No. 2 from TI and synthesizer/level generator.
19