TB 9-4931-541-50
Figure 2. Gimbaled fixture and length gauge.
f.
Loosen yoke thumbscrew and
adjust YOKE
(fig. 2) so that the
length gauge shaft is
in direct vertical alignment with the TI shaft. Tighten yoke thumbscrew.
g. Adjust the TI course adjustment knob so that the TI contact surface is fully raised.
Loosen gimbaled fixture mounting thumbscrew (fig. 1). Adjust gimbaled fixture so that the
length gauge contact point is aligned with the TI contact point (fig. 3). Tighten gimbaled
fixture mounting thumbscrew
6