Dial Indicating Depth Gage Calibration

TB-9-5210-209-35 Depth Gages (General) Manual
Page Navigation
7

TB 9-5210-209-35

Figure 3. Knife edge normally retracted dial indicating depth gage.

12. Dial Indicating Depth Gage Calibration

a. Performance Check

NOTE

Some dial indicating depth gages can be calibrated more

conveniently using dial indicator calibrator MIS-10327 and

TB 9-5210-210-50.

(1) Set up triangular base and three sets of gage blocks to measure a depth of 0.010

inch (fig. 4 and table 3) and for 1/2 inch depth gage (fig. 5 and table 4). Only center group of

blocks need to be changed.

Figure 4. Dial indicating depth gage calibration.