TB 9-5855-1892-35
Temperature error
Dip switch
Dip switch
1
2
C
A
B
C
D
+0.375 and greater
On
On
On
Off
+0.325 to +0.375
Off
On
On
Off
+0.275 to +0.325
On
Off
On
Off
+0.225 to +0.275
Off
Off
On
Off
+0.175 to +0.225
On
On
Off
Off
+0.125 to +0.175
Off
On
Off
Off
+0.075 to +0.125
On
Off
Off
Off
+0.025 to +0.075
Off
Off
Off
Off
Off
On
On
On
-0.025 to -0.075
On
Off
On
On
-0.075 to -0.125
Off
Off
On
On
-0.125 to -0.175
On
On
Off
On
-0.175 to -0.225
Off
On
Off
On
-0.225 to -0.275
On
Off
Off
On
-0.275 to -0.375
Off
Off
Off
On
-0.325 and less
(e) Perform steps 1 through 3 below:
1 Set TI ON - OFF switch to ON, and wait until READY lamp illuminates
and remains illuminated.
2 Set ON ALIGN switch to ALIGN, wait 10 seconds and set ON ALIGN
switch to ON.
3 Verify temperature error correction has been stored by observing READY
lamp blinking at 2 Hz rate.
(f) Perform steps 1 and 2 below:
1
Set TI ON - OFF switch to OFF.
CAUTION
Disconnect ac power cable from TI before changing dip switch
settings and reconnect TI ac power cable after changing dip
switch settings.
2 Set DIP SWITCH 1, A and B to on and DIP SWITCH 2, C and D to on,
then loosely replace LARGE COVER PLATE (fig. 2).
10. Final Procedure
a. Deenergize and disconnect all equipment.
back in original position and tighten TARGET SELECTOR SWITCH SCREWS (fig. 7).
