TB 9-6625-975-35
Table 3. Accessories Required
Item
Common name
Description (part number)
B1
ADAPTER
Single banana jack to spade lug (red) (7907502-2)
B2
ADAPTER
Single banana jack to spade lug (black) (7907502-1)
B3
LEAD1
24-in., No. 18; single banana plug terminations (red) (7907497)
B4
LEAD1
24-in., No. 18; single banana plug terminations (black) (797498)
1Two
required.
SECTION III
CALIBRATION PROCESS FOR I-48( ), ZM-21( )/U, BIDDLE, MODELS 679, 7675,
7676, 7676-1, 7679, 7679-1, AND 210359; WINSLOW, MODEL 5G1000, AND WESTON,
MODEL 799
6. Preliminary Instructions
process. Personnel should become familiar with the entire bulletin before beginning the
calibration.
b. Items of equipment used in this procedure are referenced within the text by common
name and item identification number as listed in tables 2 and 3. For the identification of
equipment referenced by item numbers prefixed with A, see table 2, and for prefix B, see
c. Unless otherwise specified, verify the result of each test and, whenever the test
requirement is not met, take corrective action before continuing with the calibration.
Additional maintenance information is contained in the manufacturers' manuals and TM's
11-2050, 11-2050A, and 11-6625-298-14 for these TI's.
d. Unless otherwise specified all controls and controls settings refer to the TI.
7. Equipment Setup
WARNING
HIGH VOLTAGE is used or exposed during the performance of
this calibration.
DEATH ON CONTACT may result if
personnel fail to observe safety precautions.
a. Remove TI from carrying case.
b. Place TI on a firm, level base and avoid large deposits of iron and magnetic fields.
4
