TB 9-6625-975-35
Figure 2. Resistance accuracy - equipment setup
SECTION IV
CALIBRATION PROCESS FOR M-73U (AUL MODEL 1602)
12. Preliminary Instructions
process. Personnel should become familiar with the entire bulletin before beginning the
calibration.
b. Items of equipment used in this procedure are referenced within the text by common
name and item identification number as listed in tables 2 and 3. For the identification of
equipment referenced by item numbers prefixed with A, see table 2, and for prefix B, see
c. Unless otherwise specified, verify the result of each test and, whenever the test
requirement is not met, take corrective action before continuing with the calibration.
Adjustments required to calibrate the TI are included in this procedure. Additional
maintenance information is contained in the manufacturers' manual for this TI.
d. Unless otherwise specified, all controls and control settings refer to the TI.
8
