SECTION II EQUIPMENT REQUIREMENTS - TB-9-6670-251-350003

TB-9-6670-251-35 Resilency Testers (General) Manual
Page Navigation
3

TB 9-6670-251-35

Figure 1. Typical resiliency testers.

SECTION II

EQUIPMENT REQUIREMENTS

4. Equipment Required. Table 2 identifies the specific equipment to be used in this

calibration procedure. This equipment is issued with Secondary Transfer Calibration

Standards Set AN/GSM-286. Alternate items may be used by the calibrating activity when

the equipment listed in table 2 is not available. The items selected must be verified to

perform satisfactorily prior to use and must bear evidence of current calibration. The

equipment must meet or exceed the minimum use specifications listed in table 2. The

accuracies listed in table 2 provide a four-to-one ratio between the standard and TI.

5. Accessories Required. The accessories listed in table 3 are issued as indicated in

paragraph 4 above and are used in this calibration procedure. When necessary, these items

may be substituted by equivalent items, unless specifically prohibited.