unit under test.
4. General Instructions. a. Calibration Data Card
c. Frequency of Calibration. The maximum time
During the performance of this procedure, annotate DA
permitted between calibration checks for the unit under
Form 2416 (Calibration Data Card) in accordance with
test is contained in TB 750-236.
instructions given in TM 38-750.
b. Unit Under Test. Simulator-Monitor SM 567/APS-94D
5. Difference Among Models. None.
will
hereinafter
be
referred
to
as
the
SECTION II
CALIBRATION
is listed in table 1. When any of the equipment listed is
6. Equipment Required. The equipment required for
not available, an equivalent calibrated item may be used.
calibration performance checks and adjustments
Table 1. Equipment Required for Calibration Performance
Checks and Adjustments
A. Authorized Calibration Equipment
Nomenclature
Minimum use specifications
Electronic Voltmeter ME-30 ( )/U .......................................................... 300 vac, 400 Hz.
Variable Transformer ............................................................................ 115 vac, 400 Hz.
B. Authorized Accessories
Nomenclature
Description
Test Lead Set CX-1331/U...................................................Test prod to banana plug and/or
alligator clip.
C. Additional Equipment Required
Nomenclature
Description
Test Cable Assembly No. 1 ................................................ 2 wire cable: connects unit under
test to 400 Hz supply.
Test Cable Assembly No. 2 ................................................ 12 wire cable; connects unit
under test J4 to barrier strip
Jumper wire ........................................................................ Suitable for use with barrier strip.
NOTE
Be familiar with the entire procedure before performing calibration.
3
