c. Remove shroud and remove remaining test equipment. Replace temperature
controller cover and tighten 4 screws. Disconnect and stow TI ac power cord.
d. Using cotton tip applicator soaked with paste removal solvent, clean thermally
conductive paste from TI heater plate surface. Remove solvent residue using dry cotton tip
applicator.
NOTE
If residue is severe a cotton tip applicator soaked in contact
cleaner (Krylon #1333) may be used, followed by application of
a dry cotton tip applicator.
e. Annotate and affix DA label/form in accordance with TB 750-25.
8