TB 9-5855-1892-35
READY
LAMP
ON
READY
UJ1
POWER
ON- POWER
LAMP
J1
ON
1C
4.5 C
10 C
OFF
(4) Connect remaining end of ac power cable to 115 V ac source.
(5) Set ON - OFF switch to ON.
NOTE
READY lamp will initially illuminate then extinguish for
approximately 10 seconds. READY lamp will then blink once
a second.
(6) Verify READY lamp blinks approximately once a second and POWER lamp
illuminates; if not, perform b(1) below.
g. Set ON - OFF switch to OFF.
h. Perform steps (1) through (7) below:
(1) Rotate target select knob to MRT.
(2) Set ON - OFF switch to ON.
NOTE
READY lamp will initially illuminate, then extinguish for
approximately 10 seconds. READY lamp will then blink once
a second.
(3) Verify READY lamp blinks approximately once a second; if not, perform b(1)
below.
(4) Set TI ON OFF switch to OFF.
(5) Remove LARGE COVER PLATE (fig. 2).
(6) Set ON ALIGN switch to ON (fig. 3).
(7) Loosely replace LARGE COVER PLATE (fig. 2).
6
