TB 9-6625-1997-24
Table 3. Accessories Required
Common name
Description (part number)
CABLE No. 11
36-in., RG-223/U, BNC PLUG TERMINATION
CABLE No. 21
36-in., RG-62/U, BNC PLUG TERMINATION
BNC plug to jack (50 to 25 ) TERMINATIONS (CN 900/CU)
ADAPTER No. 1
) terminations CN-901/U)
BNC plug to jack (100 to 50
ADAPTER No. 2
) to jack terminations CN-9f02/U)
BNC plug (100 to 50
ADAPTER No. 3
1
Furnished with TI.
CALIBRATION PROCESS
6. Preliminary Instructions
a. The instructions outlined in paragraphs 6 and 7 are preparatory to the calibration
process. Personnel should become familiar with the entire bulletin before beginning the
calibration.
b. Items of equipment used in this procedure are referenced within the text by common
name as listed in table 2.
c. Unless otherwise specified, verify the result of each test and, whenever the test
requirement is not met, take corrective action before continuing with the calibration.
Adjustments required to calibrate the TI are included in this procedure. Additional
maintenance information is contained in TM 11-6625-586-12 and TM 11-6625-586-45.
d. When indications specified in paragraphs 8 through 15 are not within tolerance,
perform the power supply check prior to making adjustments. After adjustments are made,
repeat paragraphs 8 through 15. Do not perform power supply check if all other
parameters are within tolerance.
e. Unless otherwise specified, all control and control settings refer to the TI.
7. Equipment Setup
WARNING
HIGH VOLTAGE is used or exposed during the performance of
this calibration.
DEATH ON CONTACT may result if
personnel fail to observe safety precautions.
REDUCE
OUPUT(S) to minimum after each step within the performance
check where applicable.
