SECTION I IDENTIFICATION AND DESCRIPTION

CALIBRATION PROCEDURE FOR OSCILLOSCOPE TEKTRONIX, TYPES SC501, SC502, AND SC504

Table 1. Calibration Description - TB-9-6625-2173-350003

TB-9-6625-2173-35 Radio Test Set TS3951/PRM34 Receiver Test Set AN/ARM-186 and Collins Model 972Q-4 Manual
Page Navigation
2

TB 9-6625-2173-35

Paragraph

Page

SECTION

IV.

CALIBRATION PROCESS FOR TEKTRONIX,

TYPE SC502

Preliminary instructions........................................

Equipment setup ....................................................

Preamplifier input capacitance .............................

Volts/div accuracy...................................................

Horizontal centering and sweep gain ...................

X10 magnifier gain and fast timing ......................

Vertical output amplifier .......................................

Vertical bandwidth.................................................

Calibrator................................................................

Power supply ..........................................................

Final procedure ......................................................

CALIBRATION PROCESS FOR TEKTRONIX,

TYPE SC504

Preliminary instructions........................................

Equipment setup ....................................................

Calibrator................................................................

Vertical gain ...........................................................

Horizontal X gain ...................................................

Vertical amplifier transient response ...................

Vertical bandwidth.................................................

External triggering sensitivity ..............................

Sweep timing ..........................................................

Power supply ..........................................................

Final procedure ......................................................

SECTION I

IDENTIFICATION AND DESCRIPTION

1. Test Instrument Identification.

This bulletin provides instructions for the

calibration of Oscilloscope, Tektronix, Types SC501, SC502, and SC504.

The

manufacturers' manuals were used as the prime data sources in compiling these

instructions. The equipment being calibrated will be referred to as the TI (test instrument)

throughout this bulletin.

a. Model Variations. Variations among models are indicated in the text.

b. Time and Technique. The time required for this calibration is approximately 1

hour, using the dc and low frequency technique.

2. Forms, Records, and Reports

a. Forms, records, and reports required for calibration personnel at all levels are

prescribed by TB 750-25.

Privacy Statement
Press Release
Contact