SECTION I IDENTIFICATION AND DESCRIPTION

CALIBRATION PROCEDURE FOR DIGITAL MULTIMETER JOHN MULTIMETER JOHN FLUKE, MODELS 8050A AND 8050A-01

Table 1. Calibration Description - Continued - TB-9-6625-2268-350003

TB-9-6625-2268-35 Digital Multimeter John Fluke Models 8050A and 8050A-01 Manual
Page Navigation
2

TB 9-6625-2268-35

SECTION I

IDENTIFICATION AND DESCRIPTION

1. Test Instrument Identification. This bulletin provides instructions for the

calibration of Digital Multimeter, John Fluke, Models 8050A and 8050A-01. The

manufacturer's manual was used as the prime data source in compiling these

instructions. The equipment being calibrated will be referred to as the TI (test

instrument) throughout this bulletin.

a. Model Variations . Model 8050A-01 has rechargeable batteries; otherwise, both

models are the same.

b. Time and Technique . The time required for this calibration is approximately 1

hour using the dc and low frequency technique.

2. Forms, Records, and Reports

a. Forms, records, and reports required for calibration personnel at all levels are

prescribed by TB 750-25.

b. Adjustments to be reported are designated (R) at the end of the sentence in which

they appear. Report only those adjustments made and designated with (R).

3. Calibration Description. TI parameters and performance specifications which

pertain to this calibration are listed in table 1.

Table 1. Calibration Description

Test

instrument

Performance specifications

parameters

(4 1/2 digit display)

Dc voltage

Range: 0 to 1000 V (in 5 ranges)

Accuracy: (.03% of reading + 2 digits)

Ac voltage

Range: 0 to 750 V (in 5 ranges)

Frequency: 20 Hz to 50 kHz1

Accuracy: (% of reading + digits)

Range

Frequency

20 Hz

45 Hz

1 kHz 10 kHz

20 kHz 50 kHz

200 mV through 200 V

1.0 + 10

.5 + 10

1.0 + 10

5.0 + 30

750 V

NOT SPECIFIED

See footnotes at end of table.

Privacy Statement
Press Release
Contact