TB 9-6625-2322-35
(9) Press TI keys as listed in (a) through (h) below.
(a) On/Off to off.
(b) More, Int/Ext to Int.
(c) Front/Rear to front.
(d) More, Locked, Previous Menu.
(e) Edit Dev, ., 2, 4, 0, MHz, Edit Dev.
(f) Mod Wave, arrow keys to ~, Select, Previous Menu.
(g) Edit Rate, 1, 0, kHz, Edit Rate.
(h) On/Off to on.
(10) Set audio analyzer controls as listed in (a) through (c) below.
(a) PRGM 99 ENTER RCL.
(b) Lo pass filter to 80 kHz.
(c) Analyzer section to measure distortion.
(11) Verify that the audio analyzer distortion indication is less than the maximum
indication listed in table 13 for distortion @ 240 kHz dev.
(12) Press TI keys as listed in (a) and (b) below.
(a) More, Unlocked Narrow, Previous Menu.
(b) Edit Rate, 1, 0, kHz, Edit Rate.
(13) Set the measuring receiver HP filter to 300 Hz.
(14) Verify that the measuring receiver indication is within the limits listed in table
(15) Press TI keys as listed in (a) and (b) below.
(a) More, Locked, Previous Menu.
(b) Edit Rate, 2, 0, 0, kHz, Edit Rate.
(16) Set the measuring receiver HP filter to 50 Hz, LP filter to >20 kHz, and set to
measure AM.
(17) Verify that the measuring receiver indication is less than the maximum limit
listed in table 13 for incidental AM @ 5 GHz.
19
