TB 9-6625-2337-24
Table 38. Output Characteristics - Continued
MAIN -25
Use the arrow keys to
--------------
-26 dB
-24 dB
highlight AUX:
AUX -50
50, ENTR (-50)
Press FUNC, ENTR keys.
AUX -25
-26 dB
-24 dB
Reestablish
MAIN 03
a reference
Use the arrow keys to
highlight GENERAL
at 0 dB first
MENUS and press ENTR
if necessary.
key.
11, ENTR (MAIN
MODULATION:)
Use the arrow keys to
highlight MODULATION:
ENTR, (OFF)
1
Press FUNC,
2, ENTR (AUX
MODULATION:)
Use the arrow keys to
highlight CW:
ENTR, (ON)
Use the arrow keys to
highlight RF:
0, ENTR (-0)
Use the arrow keys to
highlight AUX:
25, ENTR (-25)
AUX -25
Use the arrow keys to
--------------
-26 dB
-24 dB
highlight RF:
MAIN -50
50, ENTR (-50)
1
Disconnect measuring receiver sensor module from TI 1030 MHZ OUTPUT and connect sensor module to TI MAIN
RF I/O 1W TO 10KW OUTPUT.
2
Perform after measurement is made.
3Move power sensor from MAIN RFI/O 1 TO 10 KW to the AUX RF I/O connector.
(18) Disconnect equipment setup.
b. Adjustments. No adjustments can be made.
24. Modulation
a. Performance Check
(1) Connect the TI MAIN RF I/O 1W to 10 KW output connector to the crystal
detector then connect crystal detector to oscilloscope channel 2 input.
(2) Connect TI IFF VIDEO OUT CHAL/TAG to oscilloscope channel 1 input using
a 75
feedthrough termination.
(3) Press TI keys as listed in (a) through (o) below:
Press FUNC, ENTR keys.
(a)
Use the arrow keys to highlight GENERAL MENUS and press ENTR key.
(b)
3, ENTR (1ST REPLY).
(c)
Use the arrow keys to highlight M2:.
(d)
ENTR (ON).
(e)
