Figure 3. Knife edge normally retracted dial indicating depth gage.

Calibration Procedure For Depth Gages Page Navigation
7

TB 9-5210-209-24

12. Dial Indicating Depth Gage Calibration

a. Performance Check

NOTE

Some dial indicating depth gages can be calibrated more

conveniently using dial indicator calibrator MIS-10327 and

TB 9-5210-210-50.

(1) Set up triangular base and three sets of gage blocks to measure a depth of 0.010

inch (fig. 4 and table 3) and for 1/2 inch depth gage (fig. 5 and table 4). Only center group of

blocks need to be changed.

Figure 4. Dial indicating depth gage calibration.