TB 9-5895-1913-40
Table 2. Minimum Specifications of Equipment Required - Continued
Manufacturer and model
Common name
Minimum use specifications
(part number)
POWER METER
Compatible with Sensor
Agilent Model E4419B (E4419B)
Model E9304A-H18
POWER SENSOR
Frequency: 100 kHz to 4 GHz Agilent Model E9304A-H18
Amplitude: +20 to -47 dbm
Accuracy: 1.17% (2%)
TIME/FREQUENCY
Frequency: 10 MHz
Datum, Model ET6000-75
WORKSTATION
(13589305)
Accuracy: 5 x10-10
CALIBRATION PROCESS
6. Preliminary Instructions
a. The instructions outlined in paragraphs 6 and 7 are preparatory to the calibration
process. Personnel should become familiar with the entire bulletin before beginning the
calibration.
b. Items of equipment used in this procedure are referenced within the text by common
name as listed in table 2.
c. Unless otherwise specified, verify the result of each test and, whenever the test
requirement is not met, take corrective action before continuing with the calibration.
Adjustments required to calibrate the TI are included in this procedure. Additional
maintenance information is contained in the manufacturer's manual for this TI.
d. Unless otherwise specified, all controls and control settings refer to the TI.
7. Equipment Setup
WARNING
HIGH VOLTAGE is used or exposed during the performance of
this calibration.
DEATH ON CONTACT may result if
personnel fail to observe safety precautions.
REDUCE
OUTPUT(S) to minimum after each step within the
performance checks where applicable.
NOTE
Before connecting TI, the protective earth terminal of the
instrument must be connected to the protective conductor of
the line power cord. The line plug shall only be inserted in a
socket outlet provided with a protective earth contact. The
protective action must not be negated by the use of an
extension cord (power cable) without a protective conductor
(grounding). Grounding one conductor of a two-conductor
outlet is not sufficient protection.
a. Connect TI to 115 V ac power source.
b. Set TI POWER switch to ON and allow at least 24 hours for TI to stabilize.