TB 9-6625-1932-35
SECTION III
(SECONDARY REFERENCE ONLY)
6. Preliminary Instructions
process. Personnel should become familiar with the entire procedure before beginning the
b. Items of equipment used in this procedure are referenced within the text by common
name as listed in table 1.
c. Unless otherwise specified, verify the result of each test and, whenever the test
requirement is not met, take corrective action before continuing with the calibration.
7. Equipment Setup
CAUTION
Do not twist the body of power sensor when connecting and
disconnecting. Twisting can cause major damage to the power
sensor circuit.
a. If Hewlett-Packard, Model 11528A adapter/cable is not available, fabricate
adapter/cable according to figure 1.
Figure 1. Power measurement system adapter/cable fabrication.
5
