TB 9-6625-2280-40
(14) Connect multimeter (dc mode) LO lead to A6TP1 (A7TP1) (fig. 3).
(15) Connect multimeter (dc mode) HI lead to A6TP13 (A7TP13) (fig. 3).
(16) Adjust A6R113 (A7R113) (fig. 3) for a multimeter indication between -0.001 and
+0.001 V dc offset.
(17) Disconnect TI from equipment setup.
(18) Repeat (6) through (17) above for A7 board.
(19) Press RESET pushbutton located on TI rear panel.
(20) Press TI keys as listed in (a) through (d) below:
(a) MENU key (eleven times).
(b) F1 key.
(c) 1 using number key.
(d) F2 key.
NOTE
If TI requires detector calibration when TI prompts
"CONNECT DETECTOR TO CALIBRATOR THEN PRESS
ANY UNITS KEY", perform the instructions and then press 7
data entry key.
(21) Connect multimeter (dc mode) to ANALOG A output on TI rear panel.
(22) Adjust A6R47 (fig. 3) for a multimeter indication between -0.01 and +0.01 V dc.
(23) Press F3 key. Multimeter will indicate between 2.975 and 3.025 V dc.
(24) Press F1 key. Multimeter will indicate between -4.965 and -5.035 V dc.
(25) Press F2 key.
(26) Move multimeter (dc mode) connection from ANALOG A output on TI rear
panel to ANALOG B output on TI rear panel.
(27) Adjust A7R47 (fig. 3) for a multimeter indication between -0.01 and +0.01 V dc.
(28) Press F3 key. Multimeter will indicate between 2.975 and 3.025 V dc.
(29) Press F1 key. Multimeter will indicate between -4.965 and -5.035 V dc.
(30) Disconnect TI from equipment setup.
17