TB 9-6625-2341-35
(11)
Toggle ▲ or ▼to display/highlight (▼or▼ CAL 5).
(12)
Press (F5) READY, then wait till display/highlight READY is not highlighted.
(13)
Connect equipment as shown in figure 10 below:
(14) Select pulse response of *1 attenuation by pressing pushbuttons sequence (a)
through (d) below:
(a) Toggle ▲ or ▼ to display/highlight (▲ or ▼CAL 6).
(b) Set oscilloscope calibrator to produce a square wave, 1 kHz at 300 mV P-P.
(c) Press (F5) READY, then wait till display/highlight READY is not
highlighted.
28