TB 9-6625-2097-35
NOTE
Unless otherwise specified, all controls and control settings
refer to the TI.
7. Equipment Setup
a. Remove top protective cover from TI.
b. Slide all manual ink valves with tubing attached to ON position.
d. Press STOP pushbutton.
g. Energize equipment and allow 15 minutes for warmup and stabilization.
h. Press 5 mm/sec CHART SPEED pushbutton and VARIABLE SPEED control fully
ccw.
i. Turn CH. 1 POSITION control fully ccw. Adjust CH. 1 R202, LIMIT LEFT (CH. 2
R202) (fig. 1) for 1.5 mm pen deflection beyond the left channel margin.
j. Turn CH. 1 POSITION control fully cw. Adjust CH. 1 R203 LIMIT RIGHT (CH. 2
R203) (fig. 1) for 1.5 mm pen deflection beyond the right channel margin.
k. Adjust CH. 1 POSITION control to center pen on chart (0, line).
1. Repeat technique of (i) through (k) above for CH. 2 POSITION control.
Figure 1. Model 2200S (Series) - top view.
5
