TB 9-6625-2274-40
Low edge amplitude risetime ...............................
High edge amplitude risetime and aberrations ..
Markers mode .......................................................
Final procedure .....................................................
ADJUSTMENT PROCESS FOR
PROGRAMMABLE CALIBRATION
GENERATOR TEKTRONIX, TYPE CG-5011
Preliminary instructions .......................................
Equipment setup ...................................................
Power supply..........................................................
Calibration factors .................................................
Offset ......................................................................
Low edge risetime..................................................
Mid and high edge offset .......................................
Time markers.........................................................
CALIBRATION PROCESS FOR
PROGRAMMABLE PULSE HEAD
TEKTRONIX, TYPE 015-0611-00
Preliminary instructions ...............................
Equipment setup ...........................................
Fast edge pulse amplitude mode ..................
Fast edge pulse risetime ...............................
Fast edge leading edge aberrations..............
Fast edge pulse frequency.............................
Final procedure..............................................
SECTION I
IDENTIFICATION AND DESCRIPTION
1. Test Instrument Identification.
This bulletin provides instructions for the
calibration of Programmable Calibration Generator, Tektronix, Type CG-5011 and
Programmable Pulse Head, Tektronix, Type 015-0611-00. Specification Sheet,
M I S - 38938/1 and the manufacturers' manual were used as the prime data sources in
compiling these instructions. The equipment being calibrated will be referred to as the TI
(test instrument) throughout this bulletin.
a. Model Variations. None.
b. Time and Technique. The time required for this calibration is approximately 6
hours, using the dc and low frequency technique.
2. Forms, Records, and Reports
a. Forms, records, and reports required for calibration personnel at all levels are
prescribed by TB 750-25.
b. Adjustments to be reported are designated (R) at the end of the sentence in which
they appear. When adjustments are in tables, the (R) follows the designated adjustment.
Report only those adjustments made and designated with (R).
2
