TB 9-6625-2332-50
Digitizing oscilloscope
indications
Test instrument
(sec)
settings
Risetime
Falltime
Per setting
Lead setting
Trail setting
Min
Max
Min
Max
le-9
le-9
0.6e-9
1.4e-9
0.6e-9
1.4e-9
1 sec
10e-9
10e-9
8.7e-9
11.3e-9
8.7e-9
11.3e-9
20e-9
20e-9
17.7e-9
22.3e-9
17.7e-9
22.3e-9
100e-9
100e-9
90e-9
110e-9
90e-9
110e-9
100 sec
1e-6
le-6
0.9e-6
1.1e-6
0.9e-6
1.1e-6
10e-6
10e-6
9e.6
11e-6
9e-6
11e-6
10 msec
100e-6
100e-6
90e-6
110e-6
90e-6
110e-6
1e-3
1e-3
0.9e-3
1.1e-3
0.9e-3
1.1e-3
200 msec
10e-3
10e-3
9e-3
11e-3
9e-3
11e-3
(12) Press DISABLE pushbutton (model 9211 output module) to off (red light lit).
(13) Disconnect cable from TI 9211 module OUTPUT.
(14) Connect cable to TI 9215 module OUTPUT.
(15) Set digitizing oscilloscope channel 3 and trigger probe attenuation to 10.
(16) Press TI pushbuttons as listed in (a) through (h) below:
(a)
CHANNEL B
(b)
(c)
(d)
(e)
(f)
(g)
(h)
Press DISABLE pushbutton (9215 output module) to on (red light
extinguished).
(17) Setup digitizing oscilloscope to measure risetime.
(18) Verify that the digitizing oscilloscope indicates within the limits listed in table
(19) Setup digitizing oscilloscope to measure falltime.
(20) Verify that the digitizing oscilloscope indicates within the limits listed in table
(21) Set TI to the next Lead, Trail, and Per (if listed) settings listed in table 11.
(22) Repeat (17) through (20) above.
(23) Repeat (21) through (22) above for the remaining Lead, Trail, and Per settings
listed in table 11.
13
